PPF PAINT PROTECTION FILM IN TORONTO And THE GREATER TORONTO AREA.
PAINT PROTECTION FILM
It is one of the best types of protection that you can get to protect your car's paint from scratches, stone chips. It starts from $350 and goes up to $5000, it all depends on the brand and amount of coverage that your need. Basically the whole car can be wrapped in and be protected , after all you don't know where you gonna get scratched on your car. It's one of the best way to prevent damages to your paint , you can say it's worth the investment.WHAT IS PAINT PROTECTION FILM OR PPF?
Also known as Clear bra is a thermoplastic urethane often self healing film applied to painted surfaces of a new or used car in order to protect the paint from stone chips, bug splatters, and minor abrasions. This film is also used on airplanes, RVs, cell phones, electronics, screens, motorcycles and many other areas. Paint protection film is OEM approved by virtually all car manufacturers. It's transparent , not visible if it's installed properly. Some manufactures install it before customer take delivery of the car but only on high impact areas. It is made from a type of plastic that has a certain amount of elasticity, this allows it to be curved, stretched and bend around corners and bends. It is 10 times thicker than ceramic coating but not as hard as ceramic coating to allow installation on curved panels.
Full Front PPF From $800. Self-Healing And Hydrophobic
BOOK A FREE ESTIMATE
Cleaning your car regularly will protect the interior and exterior from damage from different elements which can be expensive to fix.
Book a free consultation appointment with our specialists. We’ll inspect your vehicle and make recommendations.
INSTALLATION PROCESS
It depends on the brand, but this is a general installation process.
The first step is to wash the car and polish it.
Spray the surface to where it will be applied with water and soap, and do the same to the film layer being applied.
Cut film to the size of the panel. Make sure to leave a bit extra. If it's pre-cut, then go to the next step.
Remove the backing of the film before application.
Use a squeegee to remove any excess liquid from underneath the PPF. Slowly and gently rub the squeegee on top of the film, don't put too much pressure.
Inspect the panel to make sure there is no area with bubbles left behind
Use the blow dryer or heat gun to bend the edges and make sure they are fully attached to the panel
Wipe the panel and inspect the whole car
Basic Coverage
- - Front Bumper
- - Mirrors
Partial Coverage
- - Front Bumper
- - Headlights
- - Front Of The Hood
Front End
- - Front Bumper
- - Headlights
- - Hood
- - Front Fenders
- - Mirrors
Full Coverage
- - All The Panels And Headlights
- - Optional Coverage For The Windshield
- - Price Depends On The Car